After wiring up the Evo One per directions provided on the website and flashing unit. I then performed the decryptor setup to learn the immobilizer code. I then performed the decryptor flash with the flashlink software.
After that, I could not get the RF remotes to program to the system. The antenna blinks once when I plug it in but it does nothing after that point. I tried to program the rf642 several times with no luck.
I then decided to reprogram the Evo one in order to use the stock key fobs. After trying the oem remote fobs, the ignition turned on but the car did not start, it then shut off and then turned on again as though it was trying to start the car. At which point I assumed the immobilizer was not programmed properly. So I tried to do the key program again now when plugging in the Evo one, the ignition turns on immediately.
I am not sure what I am missing, is there a way to completely reset the Evo One to like new condition to start from scratch?
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
